Route Sifam Couronne Ducati 996 St4 - 525 - 38 Dents - Similaire JTR745
    Sifam

    Couronne Ducati 996 St4 - 525 - 38 Dents - Similaire JTR745

    39,90 €
    TTC
    Couronne Ducati 996 St4 - 525 - 38 Dents - Similaire JTR745
    Guide des tailles
    Guide des tailles
    CLOTHES
    MEASUREXS/34S/36M/38-40L/40-42
    UK 6 8 10 12
    USA 4 6 8 10
    FRA 36 38 40 42
    Waist (cm) 64 68 72 76
    Chest (cm) 81 85 89 93
    Seat (cm) 89 93 97 101
    Inseam (cm) 81 82 83 84

    SHOES
    FOOT IN INCHESFOOT IN CMUSAEuroUK
    23.5 6 39 5
    24.1 6.5 39.5 5.5
    24.8 7.5 40 6
    10 25.4 8 41 7
    10¼ 25.7 8.5 41.5 7.5
    10½ 26 9 42 8
    10¾ 27.3 9.5 42.5 9.5

    How to Take Clothing Measurements

    1. Get a flexible measuring tape. These are often sold in craft stores
    2. Neck:
      • Measure around the base of the neck in inches.
      • Round up to the nearest half inch.
    3. Chest:
      • Wrap tape measure under armpits around fullest part of chest (usually right above nipples
    4. Sleeve:
      • Bend your elbow and rest your hand on your hip.
      • Have someone measure from the middle of the back of your neck to your wrist by putting the tape measure over your shoulder, around your elbow and to your wrist.
    5. Waist:
      • Wrap tape measure around where you normally wear your pants. Keep tape measure a little loose by keeping a finger between the tape measure and your waist.
    6. Inseam:
      • Put on a pair of shoes.Have someone measure from your crotch to back of the heel, where you want your pants to end.
    7. Hands:
      • Measure around the hand at the fullest part (exclude thumb). The number of inches shows the size of the glove.
    Quantité
      Available

     

    Paiement sécurisé

     

    Expédition sous 24H

     

    100% en stock

    Détails du produit

    Sifam
    25161CZ38
    23 Produits

    Fiche technique

    qualité
    Acier
    type article
    1
    Ø Intérieur
    100
    Pas
    525
    Epaisseur
    0
    Ø Entre Axe
    124
    Ø Trous
    10.5
    Nb Trous
    6
    Ø Trous 2
    0
    Ø Entre Axe 2
    0